Kb-electronics KBRG-255 Manual do Utilizador descarregar pdf (Página 9)

FIG. 2A – LINEAR TORQUE CURVE

FIG. 2B – NON-LINEAR TORQUE CURVE

III. SETTING SELECTABLE JUMPERS.

The KBRG-255 has customer selectable jumpers which must be set before the control can be

used (refer to fig. 1 p. 3). Bold indicates Factory Setting. (See sec. II, p. 4 for J7 and J8

settings.)

A. J4 - Tach-generator Voltage – (Note: Selection of the jumper position is not required if

armature feedback is used.) Place J4 jumper in the position "7V", "20/30V," "50V" that

corresponds to the tach-generator voltage in Volts/KRPM. Note: The tach voltage jumper

position is based on motor speed of 1,800 RPM.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Sem comentários

Kb-electronics KBRG-255 Manual do Utilizador Página 9