Kb-electronics Installs on end of KBVF Manual do Utilizador descarregar pdf (Página 14)

TABLE 1 – GENERAL PERFORMANCE SPECIFICATIONS

II. INSTALLATION INSTRUCTIONS

See figure 2, SIVF Connection Diagram, on page 5.

WARNING: HIGH VOLTAGE IS

PRESENT WHILE LEDs ARE ILLUMINATED.

Before wiring the SIVF to the KBVF, disconnect all power to the KBVF and wait until “PWR”

and “ST” LEDs are no longer illuminated.

A. Wiring the SIVF to the KBVF – (Note: Do not install the SIVF to the KBVF until wiring

is completed.)

1. Remove the F-S-R jumper which is installed on CONN2 of the KBVF. Attach the

3-pin connector (with white, black, and red wires) from the SIVF to the KBVF con-

nector marked “CONN2”.

2. Attach the red wire from the SIVF to the KBVF terminal marked “J3”.

3. Attach the orange wire from the SIVF to the KBVF terminal marked “P2”.

Voltage Following Operation Input Range (V DC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 – 2.5 thru 25

Current Following Operation Input Range (mA DC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 – 20

Potentiometer Operation (KΩ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Output Voltage at P2 (V DC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 – 5

MIN Trimpot Range (with 0 Volts Input) (% Full Speed) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 – 40

MAX Trimpot Range (with 5 Volts Input) (% Full Speed) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70 – 110

FWD and REV Input Switch Types . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Dry Contact or Open Collector

Linearity (%) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5

Thermal Drift (mV/ ˚C) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.0

Electromagnetic Compatibility (V/m at 80-1000M Hz) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Note: If the KBVF contains a finger safe cover,

(KB P/N 9473) see

Addendum I on page 15.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comentários a estes Manuais

Sem comentários

Kb-electronics Installs on end of KBVF Manual do Utilizador Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Software Kb-electronics Installs on end of KBVF